WE LOVE VINYL. WE DO. What's not to love? All of our unique, subtle and not-so-subtle vinyl wall decals are easy to apply to any smooth surface that needs a little personality. They're inexpensive, creative, lovable and even removable! Whether you stick them on a wall, window, table, floor or door, these unique vinyl decals will add interest and character to any surface.

Vinyl Application Instructions

Vinyl Decal Application Instructions

Our vinyl decals will stick to any smooth, dry surface as long as it’s clean. So, wipe down the area before you start.

First, make sure the vinyl image is stuck to the translucent transfer tape. To do this lay it on a hard, flat surface image side down. Then firmly rub or squeegee the entire backing with your hand, a credit card, spatula, CD jewel case, anything that won’t damage the decals.

Next, you’ll want to tape your vinyl decals to your selected surface before you actually start applying the image. This will give you a chance to decide if it’s positioned exactly where you want it. Depending on how you’re positioning them, you may need to cut loosely around each image so you can arrange them as you wish.

Now, begin at one corner and start peeling away the paper backing. Some more intricate patterns may want to stick to the backing. In this case roll back a bit and repress the decal onto the transfer tape.

Finally, hold both sides of the transfer tape (with the vinyl decal attached, of course) and stick it to your surface. Smooth one edge onto the surface first, to avoid wrinkles and bubbling, and continue firmly smoothing out the tape all the way across.

Now that its smoothly stuck down you’ll need to remove the transfer tape. Start by peeling up one corner and slowly roll it back along your surface. If any part of the decal sticks to the tape, simply stop pulling, roll back a bit and repress the image onto the surface and continue peeling away.

How easy was that? We’re sure it looks fab, so snap a photo and email it to us. We’d love to see what you’ve created!

You can remove our vinyl wall art from most surfaces. Just pick at an edge with your fingernail and slowly peel the decal off your surface. If you’ve applied your image to a less porous surface like glass, just blow-dry (set on low heat) to warm it up. This will release the adhesive and make it even easier to peel off. There, you’re back to the same boring surface you had before. Remember, once you’ve removed our vinyl wall art, it can’t be repositioned for reuse.